Thread: Makura
View Single Post
  #8  
Old 04-14-2018, 04:42 PM
hdsc hdsc is offline
Member
 
Join Date: Dec 2010
Location: Oakland, CA
Posts: 52
Default

Just tested VCV Rack & Numerology OSC capabilities and happy to say everything works as expected. TrowaSoft's cvOSCcv let's you send VCV Rack's cv over to Numerology super easy. Within Numerology, you can then use the "Learn OSC" function to control parameters.

One thing that you have to make sure though, when you setup Numerology's Generic OSC Controller, the OSC Port has to be the same as TrowaSoft's cvOSCcv Out Port. For my case, it was 7000.

Also to note, if you want to control a parameter of an AU Synth or FX, the trick I found was to "Add Modulation" to that parameter with a Sequencer. Then make the start and end point of the sequencer 1 & 1. "Learn OSC" on that first node and you're good to go. {After some thought, the Fader Box and ParamMod may be the best ticket to achieve this.}

Last edited by hdsc; 04-16-2018 at 04:55 PM.
Reply With Quote